Datamax-O'Neil Labelpoint Programmer’s Manual - Manual (Page 52)

PROGRAMMER’S REFERENCE MANUAL
Printer settings
Page 48
100
Reverse paper feed, in
1
/
10
mm. When set, the printer automatically reverse
feeds the paper the specified distance before printing. This is used for
layouts starting at the very start of the label, when parameter 24 is set to
position the paper for tear-off. Valid values for n are all positive numbers.
Default is 0.
101
...
106
Set the inter-character space for bitmap font number. Each bitmap font has
an individual inter-character spacing that may be changed in order to
compress or expand the text. ///Bitmap fonts are deprecated, but kept for
backward compatibility!
132 Enable mapping of barcode information. Normally barcode information is not
mapped since it is not considered to be readable text but rather binary
information. Valid values for n are {0,1} and they are interpreted as follows:
0 = barcode mapping disabled (default)
1 = barcode mapping enabled
134
4
Enable recover page. If a printout is interrupted by media end or ribbon end
and then media or ribbon is replaced, a copy of the last printout can be
printed in order to make sure that the whole previous printout is printed.
Valid values for n are {0, 1} and they are interpreted as follows:
0 = recover page disabled
1 = recover page enabled (default)
136 PDF code security level. Valid values for n are {0, 1, …, 8}. Default is 4. This
can also be set with the service command !V61.
137 PDF417 max number of columns. Valid values for n are all positive numbers.
Default is 0, which is interpreted as no limit. This can also be set with the
service command !V61.
138 PDF417 max number of rows. Valid values for n are all positive numbers.
Default is 0, which is interpreted as no limit. This can also be set with the
service command !V61.
145
4
Timeout value for Telnet connections, in seconds. Valid values for n are
{0, 1, …, 7200}. Default is 0, which is interpreted as no timeout.
146 Linespacing, in percent of total font height. This parameter sets the distance
between the lines in a textfield containing a CR. Valid values for n are {0, 1,
…, 999}, where 0 is the default value and interpreted by the printer as 100%.
150
4
Communication mode for COM1. Valid values for n are {0, 1, 2} and they are
interpreted as follows:
0 = Print mode (Labelpoint, default)
1 = Terminal server mode
2 = Terminal client mode
3 = RF-ID mode
4 = Stacked printers mode (daisy chaining)
See section ‘Communication ports’ for further information.