Datamax-O'Neil Labelpoint Programmer’s Manual - Manual (Page 44)

PROGRAMMER’S REFERENCE MANUAL
Service commands
Page 40
61 [r] [c] Set security level for PDF 417. Parameter s is the security level
ranging from 0 to 8. Parameter r is number of rows and parameter c
is number of columns. If r and c are omitted (or set to 0), Labelpoint
automatically adjusts height and width of the PDF code. If r is set
but c is omitted, then the PDF code will have fixed number of rows,
which means that only the width of the PDF code will grow with
increasing number of characters.
63 Get printer serial number.
74 If m = 1 the printer will send a form-feed character (ASCII 12= 0C
16
)
at the beginning of every print cycle.
m = 0, disables this function
This command allows an external controller to monitor the number
of print cycles without polling the printer.
80 Show Agfa MicroType™ typeface by index . The response is a
string in the form: ““
81 Show TrueType typeface by index . The response is a string in
the form: ““
93 [m] If m is omitted the total number of dormat printouts that have been
printed is returned. The number is calculated since restart and
!p was sent for the first time. To reset the counter set m to 99.
See Dormant print for more information.
100 ... Set network IP address.
See section ‘Communication ports -> NET’ for more info.
101 Get network IP address. Use service command 108 if DHCP is used.
102 ... Set network IP mask.
See section ‘Communication ports -> NET’ for more info.
103 Get network IP mask. Use service command 108 if DHCP is used.
104 <”host”> Set network host name.
See section ‘Communication ports -> NET’ for more info.
105 Get network host name.
106 <”m”> Set domain name.
107 Get domain name.
108 [m] Get DHCP info received from DHCP server, if any. Valid values for
m are 0, 1, 2 and the following information can be received:
0 – IP address
1 – IP mask
2 – Gateway
110 ... Set network default gateway.
See section ‘Communication ports -> NET’ for more info.