beautypg.com

Datamax-O'Neil E-Class Mark III Operator’s Manual User Manual

Page 77

background image

Appendix B – WLAN & LAN Setup

71

B.2.1 Wireless Setup – Infrastructure

After a successful setup is made via a wired connection, the Wireless connection (if equipped) can now be

configured in infrastructure mode using a static or DHCP issued IP address.

1. Open your web browser. Type in the IP

Address of the printer. The Default IP is:

192.168.10.26.

If a different IP Address has been

assigned to the printer, make sure to

enter the correct IP address.

A page similar to the right will appear:

2. Click on the “Wireless Ethernet Settings” menu item on the left side of the screen. Locate and set the

following items:

In the “Acquire Address Method” section, select the “Use DHCP” radio button.

For static IP setup:

In the “Acquire Address Method” section, select the “Use Static Addresses” radio button.

In the “Static IP Addresses” section, enter valid static IP addresses for Printer IP Address,

Printer Subnet Mask, and Printer Gateway.

3. Scroll down the page to “Network Type”, select “infrastructure” from the drop down box.

4. In the SSID field type the name of the SSID of your access point.

5. Under the “WIFI Security and Authentication”, set any security/authentication settings necessary for

your network.

6. Scroll down to the bottom of the page, enter the password (default is “sysadm”) and click Apply.

7. Click on the “General Network Settings” menu item on the left side of the screen. Locate and set the

following items:

8. In the “Network Interface”, select the “Wireless Ethernet” radio button

9. Scroll down to the bottom of the page, enter the password (default is “sysadm”) and click Apply.

10. Click on the “Restore Defaults/Restart” menu item on the left side of the screen. Be sure that Restart

Printer is displayed in the “Action to Execute:” drop down box. Enter the password at the top of the

page (default is “sysadm”) and click Execute to restart the printer.