beautypg.com

Datamax-O'Neil E-Class Mark III Operator’s Manual User Manual

Page 12

background image

6

Chapter 2 – Printer Setup

4) Pull out enough media to exit the front of

the printer. Adjust the Media Guides so

they are lightly touching the edge of the

media.

5) If using thermal transfer media (ribbon) proceed to Section 2.4 Loading Ribbon. Otherwise close

the printer’s Cover and press downward until latched. Pro

Pro+ models are equipped with a Cover Release Latch. Press outward on the latch to release cover.

312

Cover

Cover Release Latch

(Pro+ models only)


6) Press the

button to advance the media (if the Fault Light is lit, see Section 3.7.)

The printer is factory set to use gap media. If using another media type (for example, continuous

media), printer setup must be reconfigured; see Section 3.4

.