Datamax-O'Neil E-Class Mark III Operator’s Manual User Manual
Page 32
26
Chapter 3 – Printer Operation
3
3
3
.
.
.
7
7
7
M
M
M
e
e
e
d
d
d
i
i
i
a
a
a
C
C
C
a
a
a
l
l
l
i
i
i
b
b
b
r
r
r
a
a
a
t
t
t
i
i
i
o
o
o
n
n
n
3.7.1 Quick Calibration
Ensure the printer is properly loaded with media, proceed with calibration as follows:
This calibration is not necessary when using continuous stock.
Media containing large gaps may require a change in the Paper Out Distance before proceeding.
Calibrate the printer as follows:
Step
Action
Displayed Message
Comment
A
Turn ON the printer.
Wait briefly for initialization to
complete.
B
Using the
button scroll to MENU
and press the
button.
Make sure MEDIA SETTINGS is
highlighted and press the
button.
Then using the
button, scroll to
SENSOR CALIBRATION.
(Printer Menu)
C
Press the
button to access
SENSOR CALIBRATION.
Make sure QUICK CALIBRATION is
highlighted and press the
button.
Using the
button, scroll to YES
and then press the
button to
proceed.
Quick Calibration
No
>Yes
Select NO to abort this
procedure.
D
With the media installed and the
cover closed, press and hold the
button until at least 2 full labels
have been fed from the printer and
then release.
Press/Hold Enter Key
There are two possible outcomes:
CALIBRATION COMPLETE - will be displayed, and the media will be advanced to the next top of form
if calibration was successful; or,
CALIBRATION FAILED will be displayed if calibration was not successful. In this case, check the hints
listed below to help resolve the problem:
Calibration Hints:
WARNING LOW BACKING is a normal message when calibrating die-cut media mounted on a highly
translucent liner or notched tag stocks.
If the initial attempt fails, perform the Manual Calibration routine, see Section 3.7.2.