ClimaCool UGW Manual - Manual (Page 4)

www.climacoolcorp.com
2
Inspection
Upon receipt of equipment, carefully check the shipment
against the bill of lading and inspect each chiller for any
damage incurred during shipment . Thoroughly check for
any visible damage of control panels and electrical
and/or refrigeration components or broken copper lines .
The carrier must make proper notation of any damages or
shortages on all copies of the bill of lading and complete
a common carrier inspection report prior to your final
acceptance of the shipment . Note: It is the responsibility
of the purchaser to file all necessary claims with the
carrier. In addition, please notify the ClimaCool Customer
Service Department at 405.815.3000 or customerservice@
climacoolcorp.com of all damage immediately.
Storage
Chillers should be stored in an upright position and kept in a
clean, dry area .
Handling of Modules
Carefully remove the module’s packaging . The chiller’s
steel base cutouts provide maneuverability by forklift or
pallet jack into its final position (See Rigging and Lifting
Procedures on page 7) . Verify that all header grooved
couplings and mounting hardware kits are on site prior to
connecting the modules . Note: Consult factory for handling
other than in the upright position.
Rigging and Lifting
Each module should be lifted using a pallet jack or fork
lift . If it is necessary to utilize a crane for rigging or lifting,
each module shall be lifted using lifting straps and spreader
bars using rigging points identified on Rigging and Lifting
Procedures on page 7 .
Warranty
To ensure proper equipment longevity, design performance
and reliability, all ClimaCool chillers must be installed,
operated and maintained in accordance with ClimaCool
IO&M manuals . Water quality is of the utmost importance
for the proper care and maintenance of your modular
chiller system . Regular treatment of the water will increase
longevity of your system . Failure to provide adequate
filtration or treatment of evaporator and condenser
water will void the ClimaCool module’s warranty. A
factory authorized technician is required to perform
the startup of your ClimaCool chiller . Please contact the
ClimaCool Customer Service Department at 405-815-3000 or
technicalsupport@climacoolcorp .com to schedule . There is
a minimum of three (3) weeks’ notice required to schedule
your factory startup.
Pre-Installation