Project validation, Configure device – MoTeC Display Creator User Manual
Page 65

Configure Device
65
www.motec.com
Display Creator User Manual – MoTeC Ⓒ 2014 Published 1 July 2014
Project Validation
A display configuration cannot be sent to the device if it is not valid, for this reason, check the validation before
sending.
Use the
Device > Validate Project...
menu to validate the project configuration.
If the validation fails, the issues that caused failure are listed in the Project Validation Messages pane. Resolve
the issues and try again.
Configure Device
Use
Device > Configure Device...
menu or the
Configure Device
button. A list of possible devices
displays; select the appropriate device to send the configuration to, and select the
Send
button.
☛
• Sending a configuration will automatically save the project.
• A display configuration cannot be sent if it is not valid. If an attempt is made to send the configuration
and it fails due to validation problems, the issues that caused the failure are listed in the Project
Validation Messages pane. Resolve the issues and try again.