Create representative tick mark text – MoTeC Display Creator User Manual
Page 35
Page Elements
35
www.motec.com
Display Creator User Manual – MoTeC Ⓒ 2014 Published 1 July 2014
☛
The Configure Ticks window displays the current configuration, but not any non-linear adjustments. It will
always adjust the configuration to a linear progression based on the values and configuration selected.
Major Divisions
Set the number of major divisions (does not include the initial
position) and the start and end values. Ten would give 11
positions including the start.
Tick Text
The ticks can be same as the value or different.
Minor Divisions
Set whether minor divisions are required and the number of
divisions between each major division.
Create Representative Tick Mark Text
Sometimes the tick mark text is best shown as text that is representative of the actual value, such as on a
tachometer (which is the displayed text x1000). The method for doing this is shown in the following example.
This configuration gives the result shown at right.