Adding sweeps – MoTeC Display Creator User Manual
Page 48
48
Page Elements
Display Creator User Manual – MoTeC Ⓒ 2014 Published 1 July 2014
www.motec.com
Adding Sweeps
Sweep elements are bracketed sections of the dial that can be used as visual cues. In the example below, three
sweeps are added with varying properties such as no fill, and various radius and width settings.
To include a sweep on a dial:
1.
Select the dial.
2.
From the right-click menu, select
Insert > New Sweep
.
☛
The sweep will not display on the dial unless a start and end value is entered.
Sweep
Radius
As the radius changes, it moves the whole element
to, or away from the centre.
Width
As the width changes, the inner border either
expands to, or retracts from the centre.
Start
Where to begin the sweep.
Value
End
Where to end the sweep.
Value
Border
Use to set the border characteristics as required.
Fill
Use to set the border characteristics as required.