B&K Precision 4078 - Manual - Manual (Page 74)

2) The end address must be greater than the start address.
4.13.4.6 Copy
:ARBitrary:COPY ,,
This command is used to copy a section of the waveform to a different location in waveform memory.
Arguments
Type:
NRf
Range: 1 to 400,000
Rounding: to integer value
Command Type: Setting only
Setting
Syntax:
:ARBitrary:COPY,,
Example: :ARB:COPY 1,1000,1001
Considerations:
1) The destination range cannot overlap with protected memory.
2) The destination range cannot overlap with the source range.
3) The destination end address may not exceed the maximum address:
Destination address + Length - 1 <= 131072
4.13.4.7 Memory Protection Range
:ARBitrary:PROTect [:RANGe] ,
This command is used to define a range of arbitrary waveform memory to be write-protected. The protection is
effective only if the PROTect:STATe is ON.
Arguments
Type:
Numeric.
Numeric Range: 1 to 400,000
Rounding:
to integer value.
Command Type: Setting or Query
Setting
Syntax:
:ARBitrary:PROTect[:RANGe],
Examples: :ARB:PROT 1,1E3
Query
Syntax:
:ARBitrary:PROTect[:RANGe]?
Response: , in NR1 format.
4.13.4.8 Memory Protection State
:ARBitrary:PROTect:STATe
This command is used to enable or disable arbitrary waveform write-protection.
Arguments
Type:
Boolean
Command Type: Setting or Query
Setting
Syntax:
:ARBitrary:PROTect:STATeON|1|OFF|0