B&K Precision 4078 - Manual - Manual (Page 36)

Setting conflict Can't have this parameter set with some other.
Trig rate short Internal trigger rate too short for wave/burst.
Empty location Attempt to restore non existent setting.
SCALE too high Attempt to set scale too high for current dot value
Protected RAM Attempt to write to protected RAM range.
Save RAM New firmware installed.
Must divide by 4 Predefined wave length must be divisible by 4.
Must divide by 2 Predefined wave length must be divisible by 2.
3.13 Using Model 4075 and 4078
This section explains how to generate various waveforms and modify the output waveforms.
3.13.1 Selecting a Standard Waveform
You can select several standard waveforms as: sine, triangle and square. Creating a standard waveform requires
selecting the waveform type, parameters, modes, etc., and their settings that define the waveform.
Generating a standard waveform requires the following:
* Selecting the waveform by pushing any of the waveform buttons (Sine, Ramp, Square, Pulse, or Arb)
* Setting the output frequency by using the rotary input knob or numeric keypad to enter the desired frequency.
* Setting the output amplitude and offset by selecting the option in the function menu and using the rotary input
knob or numeric keyboard to enter the desired amplitude and/or offset.
3.13.2 Setting the Output Mode
To set the output mode:
1. Press MODE to display the Mode menu on the display window.
2. Press the function key (Fl to F4) that corresponds to the desired mode. Choose from Continuous, Trigger, Burst,
and Gate mode. You can also adjust the Phase in the same menu.
3.13.3 Setting the Output
To set the output channel, press the Output ON key. An internal LED is illuminated to indicate that the Output is
ON.
3.14 Examples
3.14.1 Creating an Arbitrary Waveform
You can create an arbitrary waveform using the following methods:
* Enter individual data points