B&K Precision 4078 - Manual - Manual (Page 63)

4.13.1.9.2 FSK LOWFrequency
This command sets the lower of the two frequencies used in FSK modulation.
Arguments
Type:
Numeric.
Units: MHz, KHz, Hz (default)
Range: The whole frequency range of the current function.
Rounding: The value is rounded to 4 digits.
Command Type: Setting or Query
Setting
Syntax:
[:SOURce:]FSK:LOWFrequency[units]
[:SOURce:]FSK:LOWFrequencyMINimum|MAXimum
Examples: FSK:LOWFrequency 5KHZ
FSK:LOWF 5E3
FSK:LOWF MAXIMUM
FSK:LOWF MIN
Query
Syntax:
[:SOURce:]FSK:LOWFrequency?[MAXimum|MINimum]
Examples: FSK:LOWF?
FSK:LOWF? MAX
Response: NR3
4.13.1.9.3 FSK HIFrequency
This command sets the higher of the two frequencies used in FSK modulation.
Arguments
Type:
Numeric.
Units: MHz, KHz, Hz (default)
Range: The whole frequency range of the current function.
Rounding: The value is rounded to 4 digits.
Command Type: Setting or Query
Setting
Syntax:
[:SOURce:]FSK:HIFrequency[units]
[:SOURce:]FSK:HIFrequencyMINimum|MAXimum
Examples: FSK:HIFrequency 5KHZ
FSK:HIF 5E3
FSK:HIF MAXIMUM
FSK:HIF MIN
Query
Syntax:
[:SOURce:]FSK:HIFrequency?[MAXimum|MINimum]
Examples: FSK:HIF?
FSK:HIF? MAX
Response: NR3
4.13.1.9.4 FSK RATE
This command sets the rate of switching between the two frequencies of the modulation.
Arguments
Type:
Numeric.
Units: MHz, KHz, Hz (default)
Range: Fmax = 1MHz
Fmin = 0.01Hz
Rounding: The value is rounded to 4 digits.
Command Type: Setting or Query
Setting
Syntax:
[:SOURce:]:FSK:RATE[units]
[:SOURce:]:FSK:RATE MINimum|MAXimum