Atec Anritsu-MS4640B - Manual (Page 5)

VectorStar™ MS4640B Series High Level Noise
MS4640B Series TDS PN: 11410-00611 Rev. A 5
High Level Noise
Measured at 1 kHz IF bandwidth, at default power, with either full reflects or through transmission. RMS. Characteristic performance on MS4645B and
MS4647B with either Option 051, 061, or 062. High level noise magnitude may be degraded to 20 mdB RMS (typical) at particular frequencies due to
receiver residuals.
Noise Floor
Measured at 10 Hz IF Bandwidth with no averaging, and at –10 dBm port power. RMS, no leakage correction applied. Measurement made with a through
line connection, with its effects compensated for. Performance at a
x
and b
x
loops is characteristic.
All Models, Noise Floor (dBm)
Frequency (GHz) Magnitude (dB) Phase (degree)
70 kHz to 500 kHz < 0.04 < 0.4
500 kHz to 2.5 < 0.0045 < 0.05
2.5 to 5 < 0.0045 < 0.05
5 to 20 < 0.0045 < 0.05
20 to 40 < 0.006 < 0.06
40 to 67 < 0.006 < 0.08
67 to 70 < 0.008 (< 0.006) < 0.08
Frequency Range
At Ports 1 or 2 At a
x
Loops At b
x
Loops
Standard Option 051 Option 061 a or 062
a. The Option 061 noise floor reported in this column applies to Port 2 or b
2
. For Port 1 or b
1
noise floor, use the figures from the appropriate
Port
x
or b
x
Option 051 column.
Option 051,
061, or 062 Option 051 Option 061 a or 062
0.07 to 0.3 MHz –75 –74 –73 –105 –105 –104
0.3 to 2 MHz –92 –91 –90 –117 –117 –116
2 to 10 MHz –105 –104 –103 –125 –125 –124
0.01 to 2.5 GHz –110 –108 –104 –129 –129 –125
2.5 to 40 GHz b
b. 2.5 to 38 GHz for MS4645B and MS4647B.
–110 –107 –103 –121 –122 –118
38 to 50 GHz –110 –106 –103 –121 –121 –118
50 to 65 GHz –110 –106 –103 –121 –121 –119
65 to 67 GHz –110 –106 –100 –120 –120 –116
67 to 70 GHz –110 –106 –100 –115 –119 –116