Atec Anritsu-MS4640B - Manual (Page 36)

36 PN: 11410-00611 Rev. A MS4640B Series TDS
Rear Panel Connections VectorStar™ MS4640B Series
Rear Panel Connections
AC Power Input AC Input connector, with On/Off switch, and fuses 350 VA maximum, 90 to 264 VAC,
47 to 63 Hz (power factor controlled)
USB, PS/2, and LAN
USB Control Port Type B USB 2.0 port for controlling the instrument externally, for remote operation
USB Ports Two Type A USB 2.0 Ports for peripherals such as keyboard, mouse, memory stick, hardware key, etc. (Two more
USB ports at the front panel)
Keyboard and Mouse Ports Dedicated PS/2 ports.
LAN Port 10/100BaseT Ethernet
GPIB Ports
GPIB Port (Talker/Listener) Type D-24, female, IEEE 488.2 compatible, for controlling the instrument externally, for remote operation.
GPIB Port (Dedicated Controller) Type D-24, female, for the control of external instruments such as power meters, external test sets, and similar
devices.
External I/O Port
Type 25-pin D-Sub, female, User-defined I/O for custom external test set interface, to synchronize with different
sweep states, such as Start, Stop, Driven Port, and similar parameters.
Pin 1 Limit Pass/Fail
Pins 2, 3, 15, 16 TTL In
Pins 4, 13 14, 21 GND
Pins 5-12, 17-20, 22 TTL Out
Pins 23-25 Reserved
Serial Port 9-pin D-Sub, male, compatible with RS-232, provides control for AutoCal modules and similar devices.
VGA Port 15-pin mini D-Sub, for simultaneously projecting the instrument’s screen display onto an external VGA monitor,
with 1024 x 768 minimum resolution.
MS4640B Series Rear Panel (with Option 035)