Atec Anritsu-MS4640B - Manual (Page 26)

26 PN: 11410-00611 Rev. A MS4640B Series TDS
Measurement Times VectorStar™ MS4640B Series
Measurement Times
Measurement times include sweep time, and band-switching time, in single channel mode. Typical.
20 μs/point is achieved in true swept mode, with 25,000 points, with ALC turned on for level accuracy, with display turned-on for tuning purposes, with
locking turned-on for frequency accuracy and repeatability, with correction turned on to meet published residual specifications, and over the full span of
the product with all band-switch points to fully characterize a device.
Measurement Time (ms), SYNTHESIZED Sweep, Display ON and ALC ON
Measurement Time (ms) vs. Noise Floor (dBm), SYNTHESIZED Sweep, Display ON and ALC ON
Calibration Sweep Width IFBW
Measurement Time
401
Points
1,601
Points
25,000
Points
100,000
Points
Uncorrected or
1-port calibration
Narrow (≤ 1 GHz span
without band-switch points)
1 MHz 14 40 510 2,200
30 kHz 22 90 1,230 4,900
1 kHz 380 1,600 25,000 100,000
Wide (70 GHz span)
1 MHz 50 70 570 2,300
30 kHz 67 120 1,300 5,000
1 kHz 420 1,670 25,000 100,000
2-port calibration (per sweep)
Narrow (≤ 1 GHz span without
band-switch points)
1 MHz 14 40 510 2,200
30 kHz 22 90 1,230 4,900
1 kHz 400 1,610 25,000 100,000
Wide (70 GHz span)
1 MHz 50 70 570 2,300
30 kHz 67 120 1,300 5,000
1 kHz 420 1,670 25,000 100,000
Calibration
Full Band
Sweep
Measurement Time
1,601 Points
Achieved Noise Floor at
Maximum Frequency (dBm)
IFBW
(kHz)
2-port calibration (per sweep)
MS4642B
90 –85 100
190 –95 10
MS4644B
95 –80 100
190 –90 10
MS4645/47B
100 –75 100
190 –85 10