Atec Anritsu-MS4640B - Manual (Page 38)

38 PN: 11410-00611 Rev. A MS4640B Series TDS
Rear Panel Connections VectorStar™ MS4640B Series
Trigger Out
Connector Type BNC (female)
Voltage Output 0 to 3.3 V pulse output 1 µs positive pulse
Voltage V
(output high)
= 2 V min @ –12 mA
V
(output low)
= 0.8 V max @ +12 mA
Impedance Low impedance (approximately 50 Ω)
Pulse Generator Outputs All values listed are nominal.
Optional Requires Options 035 and 042 PulseView™
Connector Type SMA (female)
Pulse Generator Outputs P GEN 1, P GEN 2, P GEN 3, and P GEN 4
Voltage High: 3.3 V ± 10 %
Low: < 1 V
Drive Impedance Low impedance (approximately 50 Ω)
Load Impedance 50 Ω or higher impedance
Pulse Synch Input All values listed are nominal.
Optional Requires Options 035 and 042 PulseView™
Connector Type SMA (female)
Voltage Input High: 3.3 V ± 10 %
Low: < 1 V
Signal 5.5 VDC damage level
Latency 55 ns delay from received synch to T
0
(typical)
Impedance High impedance input
Pulse Synch Output All values listed are nominal.
Optional Requires Options 035 and 042 PulseView™
Connector Type SMA (female)
Voltage Output High: 3.3 V ± 10 %
Low: < 1 V
Signal 5.5 VDC damage level
Latency < 5 ns delay from T
0
to providing an external synch (typical)
Drive Impedance Low impedance (approximately 50 Ω)
Load Impedance 50 Ω or higher impedance