Atec Anritsu-MS4640B - Manual (Page 37)

VectorStar™ MS4640B Series Rear Panel Connections
MS4640B Series TDS PN: 11410-00611 Rev. A 37
Bias Inputs
Optional Requires Active Measurement Suite, Option 061 or 062
Bias Inputs BNC (female), one per port
Bias Fuses 0.5 A, 250 V, one per port
Direct Access Loops
Optional Requires Option 051, 062, or 062
Connector Type SMA (female)
Description For Source, Test, and Receive paths, 3 per port, for < 2.5 GHz frequency coverage
Damage Input Levels +20 dBm maximum, 0 VDC maximum
IF Inputs/Outputs a
1
, a
2
, b
1
, b
2
, IF Inputs/Outputs
Connector Type SMA (female)
Inputs Inputs used with external converters such as millimeter-wave modules, or for antenna testing.
Outputs Outputs used with external IF digitizers and processors.
Nominal Inputs 5 to 200 MHz (mode dependent), 0 dBm for full scale
Nominal Outputs 0.2 to 200 MHz (mode dependent), +10 dBm maximum
10 MHz In Signal presence is auto-sensing (better than 1000 ppm frequency accuracy is recommended).
Connector Type BNC (female)
Signal –10 dBm to +3 dBm, 50 Ω Nominal
10 MHz Out Derived from the internal reference, unless an external 10 MHz reference input is applied.
Connector Type BNC (female)
Signal 0 ± 5 dBm sinusoidal, 50 Ω Nominal
Analog In 1 and 2 Two independent inputs for measurements simultaneous with the RF measurements, for current sensing,
efficiency computation, power detection, and similar parameters.
Connector Type BNC (female)
Range –10 V to +10 V with automatic offset and gain calibrations
Accuracy 2 mV + 2 % for |V| < 5 V; 2 % for |V| > 5 V
Nominal Input Impedance 60 kΩ
Ext In ALC 1 and ALC 2 For external automatic level control of the internal signal source generators.
Optional ALC 1 is available with Options 080/081 and 082/083. ALC 1 and ALC 2 are both available with Options 031 and
084/085.
Connector Type BNC (female)
Ext Analog Out For external attenuator control, external switch control, analog triggering assistance, measurement system
integration, and other purposes.
Connector Type BNC (female)
Normal Operating Modes Sawtooth synch sweep, TTL indication of driving port, open loop level controller
Range –10 V to +10 V; low impedance drive
Accuracy 20 mV + 2 % (Load: > 5 kΩ)
Ext Trigger
Connector Type BNC (female)
Voltage Input 0 to 3.3 V input (5 V tolerant)
Impedance High impedance (> 100 kΩ)
Pulse Width 100 ns minimum input pulse width
Edge Trigger Programmable edge trigger
Lock Status
Connector Type BNC (female)
Voltage Input 0 to 3.3 V input (5 V tolerant)
Impedance High impedance (> 100 kΩ)
Pulse Width 100 ns minimum input pulse width
Edge Trigger Positive-edge trigger
Ready for Trigger
Connector Type BNC (female)
Voltage Input 0 to 3.3 V latched output
Impedance Low impedance (approximately 50 Ω)
Voltage V
(output high)
= 2 V min @ –12 mA
V
(output low)
= 0.8 V max @ +12 mA