Alpha Technologies Te43 - Manual (Page 40)

©
NAME DATE
APPROVED
CHECKED
DRAWN
DESIGN 2009/04
2009/05
2009/06
2009/06
ME
SDW
JK
ME
SCALE:
THESE DESIGNS AND SPECIFICATIONS ARE CONFIDENTIAL, REMAIN
THE PROPERTY OF ALPHA TECHNOLOGIES LTD., AND SHALL NOT
BE COPIED OR USED WITHOUT ITS WRITTEN CONSENT.
TYPE
0.5
D2
1
0.5
0.05
0.002]
[ 0.040]
[ 0.020]
[
UNITS: mm [in]
X [X.X]
X.X [X.XX]
X.XX [X.XXX]
ANGULAR:
OF
4/30/2009 ALPHA TECHNOLOGIES
TITLE:
ISSUE
DATE
SIZE
B
DWG NO.
CUSTOMER CONNECTION,
KIT, INTERFACE, w/ CBL
SET, PWR TO BATT, Te4x
747-602-08
SHEET
NTS
REV
P/B
1 5
ITEM
QTY
ME 10/01 KL JK ADD NOTE P/B
REVISIONS
DESCRIPTION LTR APPD DATE DWN CHKD
P/B
P/B
P/B
REMOVE SIDE ACCESS CABLE KNOCKOUTS ON
K.O. OPENINGS ON POWER ENCLOSURE SIDE ONLY.
INSTALL SEALING GASKET (ITEM 6) AROUND
(ITEM 5) WITH 4 MOUNTING SCREWS (ITEM 17). MOUNT
GASKET (ITEM 6) AROUND TOP ACCESS OPENING ON
FACING SIDES OF BOTH ENCLOSURES.
POWER ENCLOSURE SIDE ONLY. REMOVE TOP ACCESS
PANEL ON INSIDE POSITIONED TOWARDS THE FRONT
PANEL FROM FACING SIDE OF BATTERY ENCLOSURE.
REMOVED MAY BE LOCATED ON THE
WITH OPENING FOR CABLES AT REAR. INSTALL SEALING
POWER ENCLOSURE SHOWN
LEFT SIDE PANEL DEPENDING ON THE
SIDES OF BOTH ENCLOSURES (2 PER SIDE)
TO ACCEPT BOLTING HARDWARE
RIGHT SIDE VIEW
KNOCK OUTS REQUIRED TO BE
REMOVE TOP CORNER KNOCKOUTS ON FACING
ENCLOSURE CONFIGURATION
REMOVE EXISTING TOP ACCESS BLANK PANEL ON
POWER ENCLOSURE. INSTALL REPLACEMENT PANEL
SIDE KNOCKOUT REMOVAL, PANEL CHANGE &
GASKET INSTALLATION:
NOTE: ONLY REMOVE KNOCK OUTS ON
FACING SIDES OF BOTH ENCLOSURES
SIDE OF POWER ENCLOSURE
POWER ENCLOSURE
DEPENDING ON CONFIGURATION)
(MAY BE LOCATED ON THE OTHER
B
REAR VIEW
BATTERY ENCLOSURE
MOVE BATTERY ENCLOSURE INTO
POSITION LINING UP NEXT TO
POWER ENCLOSURE
A
CUT LINES
EXISTING
CUT AWAY A SMALL SECTION OF INNER
WALL INSULATION IN AREA OF SIDE
ACCESS CABLE KNOCKOUTS ON
BOTH ENCLOSURES AS SHOWN FOR
CHASE NIPPLE INSTALLATION.
INSULATION CUT DETAIL
DETAIL B - INSIDE VIEW
279 11.0
127 5.0
382 15.1
SETUP & PREPARATION:
CORNERS OF BOTH ENCLOSURES AS SHOWN
FOR 3/8" HARDWARE INSTALLATION.
DETAIL A - INSIDE VIEW
CUT AWAY A SMALL SECTION FROM
INNER WALL INSULATION IN THE UPPER
POWER AND BATTERY ENCLOSURE
INSULATION CUT DETAIL
64 [2.5]
76 3.0
©