Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Setup Programming Guide - Manual (Page 76)

SCALD Tank Leak Test Setup Page 11 - 3 11
SCALD (tank leak) Test Menu (C
ONTINUED
....
FROM PREVIOUS PAGE
)
VAPOR RECOVERY (select ENABLED when Vapor Recovery is present)
SCALD VAPOR RECOVERY
DISABLED Use UP/DOWN
▲ ▼
keys to show choices.
ENABLED Press ENTER to accept this data.
(Enable for vapor recovery systems)
ALARM ON (change to YES if you want an alarm when a SCALD
ALARM ON SCALD FAIL leak test fails)
NO Use UP/DOWN
▲ ▼
keys to show choices.
YES Press ENTER to accept this data.
TST FL OG (* This menu appears only when ALARM ON SCALD
SCALD FAIL OUTPUT GROUP FAIL – YES was chosen above)
TANK 1
TANK 2
Press the ( M ) key to select a TANK #.
: Use UP/DOWN
▲ ▼
keys to show more choices.
TANK 8
SCALD TEST FAIL OUTPUT GROUP N (32 OGs available ... see WORKSHEET # 8-1.)
NONE Not assigned to an output group (OG).
GROUP A-FF One OG selected (A=1st OG, FF=32nd OG)
ALL GROUPS All OGs selected
Use
UP/DOWN
▲ ▼
keys to show more choices.
Press ENTER to accept this data.
— Your Notes —
— ❖ —