Franklin Fueling Systems Tank Sentinel (TS-1001, 2001, 504, 508 & 750) Setup Programming Guide - Manual (Page 123)

Communication Ports Setup Page 21 - 3 21
COMM PORT 2 Menu
Use COMM PORT 2 for remote connection to
a POS terminal, or external modem, or to a
Computer system / IBM PCs (this may
require a null modem cable).
Go back to display this menu and press M2
to access the Comm Port 2 menu.
COMM PORT 2
MODE Press M1 key.
COMMUNICATIONS MODE
NATIVE Use UP/DOWN ▲ ▼ keys to show choices.
VEEDER ROOT Press ENTER to accept this data.
BAUD Press M2 key.
BAUD RATE
9600 BAUD Use UP/DOWN ▲ ▼ keys to show choices.
300 BAUD Press ENTER to accept this data.
:
19,200 BAUD
DATA BITS Press M3 key.
DATA BITS
8 BITS Use UP/DOWN ▲ ▼ keys to show choices.
7 BITS Press ENTER to accept this data.
STOP BITS Press M4 key.
STOP BITS
1 STOP BIT Use UP/DOWN ▲ ▼ keys to show choices.
2 STOP BITS Press ENTER to accept this data.
— Press the DOWN ▼ key to show more menu items —
PARITY Press M1 key.
PARITY
NO PARITY Use UP/DOWN ▲ ▼ keys to show choices.
ODD PARITY Press ENTER to accept this data.
EVEN PARITY
ECHO TEST Press M2 key.
ECHO TEST ACTIVE…
HIT ANY KEY TO QUIT
— CONTINUED ON THE NEXT PAGE —
ACCESS CODE or PHONE No. AT Command
Characters: D = ( , ) comma = dial delay
NOTE
☞
Cycle console power on and off after
programming is done, or after any COM
PORTS setting is changed. Also, when the
data / fax modem is present, press
CHECK & M3 DIALTONE to see if a dial
tone is detected.
COMM PORTS
COMM 1
COMM 2 FAX/MODEM*
M1 M2 M3 M4