Serial communication, Configuration ports, Using the mlc 52/dvcm 50 configuration program – Extron Electronics MLC 52 Series User Guide User Manual
Page 52: Program, Ogram (see, Using the mlc 52/dvcm 50 configuration
MLC 52 MediaLink Controllers • Introduction
46
MLC 52 MediaLink Controllers • Installation and Configuration
46
MLC 52 MediaLink Controllers • Operation
46
MLC 52 MediaLink Controllers • Serial Communication
46
Serial
Communication
This section describes the procedure for accessing and starting the MLC 52/DVCM 50
Configuration Program and also contains a list and explanations of the Simple Instruction
Set (SIS) commands available for the MLC 52. The following topics are covered:
•
•
Using the MLC 52 Configuration Program
•
Configuration Ports
The MLC 52 can be remotely configured via a host computer connected to the front
panel configuration port (see
on page 28). Through this port,
you can program the MLC buttons with commands by using the configuration software
(MLC 52/DVCM 50 Configuration Program). You can also issue certain SIS commands
through this port.
Using the MLC 52/DVCM 50 Configuration Program
To perform advanced configuration tasks (such as setting button modes,
updating firmware, and adding display device drivers), you must use the included
MLC 52/DVCM 50 Configuration Program. Many items in the configuration program
are also accessible via front panel controls described under
on
page 27 (see that section for details on features and settings). Some features are available
only via this configuration program. The help file provides information on settings and on
how to use the configuration program itself.
To install and run the configuration program, ensure that your computer meets the
following system requirements:
•
Microsoft Windows XP or later
•
Pentium III or better processor (or compatible)
•
32 MB free hard disk space
•
Microsoft Internet Explorer 4.0 or above
•
4x or higher DVD player
•
Minimum 1024x768 screen resolution
The configuration software is provided on a DVD, which is packaged with the MLC. The
program can also be downloaded at
Install this software on your
computer.