Extron Electronics MLS 608 D Series User Guide - Manual (Page 85)

Pasting to Multiple Locations
A selected block of elements can be cut or copied, then pasted to multiple locations.
To paste a block of elements to multiple locations:
1. Click the upper left-most element that matches the upper left-most element of the
area that you cut or copied.
2. Press and hold the key while repeating step 1 for every area to which you want
to paste. Make sure that the area to which you are pasting will not overlap.
3. Release the key.
4. Use one of the following methods to paste the block of elements.
z
From the Edit menu, select Paste.
z
Press on the keyboard.
In the figure below left, all of the processor blocks in the top two rows have been selected
(the upper left-most block is a Filter block) and then cut or copied. In the figure below
right, the upper left-most blocks have been selected (also Filter blocks) for each set of two
rows to which to paste. The first two rows will be pasted three times.
MLS 608 D Series • User Interface Navigation 79