Extron Electronics MLS 608 D Series User Guide User Manual
Page 78
Command
ASCII Command
(host to switcher)
Response
(switcher to host)
Additional
Description
RGB Delay Time
NOTE:
RGB delay affects only inputs 1-3 and if they are configured to RGB format.
Set RGB delay
EX$
D}
DlyX$]
Set RGB delay to (X$ x
0
.5) seconds.
View setting
E
D}
X$]
View RGB delay setting.
MTP Output Pre-peaking
Set output
pre-peak on
E
1Opek}
Opek1]
Turn output pre-peak on.
Set output
pre-peak off
E
0Opek}
Opek0]
Turn output pre-peak off
(default).
View status
E
Opek}
1] or 0]
View pre-peaking status.
MTP Input Signal Level Adjustment
Specify a value
EX1(
ILVL}
IlvlX1(]
Specify an input signal
level value X1(.
Increment value
E
+ILVL}
IlvlX1(]
Increase the signal level
value by 1.
Decrement value
E
-ILVL}
IlvlX1(]
Decrease the signal level
value by 1.
View current value
E
ILVL}
X1(]
View current level X1(.
MTP Input Signal Peaking Adjustment
Specify a value
EX1^
IPEK}
IpekX1^]
Specify an input peaking
value X1^.
Increment value
E
+IPEK}
IpekX1^]
Increase value by 1.
Decrement value
E
-IPEK}
IpekX1^]
Decrease value by 1.
View current value
E
IPEK}
X1^]
View current X1^.
NOTE:
X$ = RGB delay for inputs 1-3: maximum delay is 5 seconds, in 0.5 second intervals, default = 0 seconds
X1^ = Input signal peaking adjustment range: 0 to 255 (default = 0)
X1( = Input signal level adjustment range: 0 to 255 (default = 60)
MLS 608 D Series • SIS Programming and Control
72