Extron Electronics MLS 608 D Series User Guide User Manual
Page 16
MLS 608 D Analog Signal Transmission Distance Table for Inputs and Outputs, in Feet and (Meters)
NOTE:
• The maximum transmission distances are determined by the frequency and resolution of the video signal being
routed. The table below specifies the recommended maximum distances when using Extron Enhanced Skew
Free AV UTP cable or UTP CAT 5, 5e, or CAT 6 cable, terminated with RJ-45 connectors.
• The minimum TP cable length should be 25 feet from the MTP Tx to input 4.
• It is possible to exceed the recommended distances; however, image quality may be reduced.
Video Format
MLS Pre-Peak
Maximum Distance
Off
On
High Quality
Variable Quality
MLS Input
MLS Output
MLS Input
MLS Output
Component,
S-video
<300 (90)
>350 (105)
700 (215)
700 (215)
700 (215)
800 (245)
Composite
<300 (90)
>350 (105)
700 (215)
700 (215)
750 (230)
750 (230)
640x480
<300 (90)
>350 (105)
550 (170)
600 (185)
600 (185)
650 (200)
800x600
<300 (90)
>350 (105)
500 (150)
500 (150)
600 (185)
600 (185)
1024x768*
<300 (90)
>350 (105)
450 (135)
450 (135)
550 (170)
550 (170)
1280x960*
<300 (90)
<350 (105)
350 (105)
350 (105)
450 (135)
450 (135)
1280x1024*
<250 (75)
>300 (90)
350 (105)
350 (105)
450 (135)
450 (135)
1360x765
<250 (75)
>300 (90)
350 (105)
350 (105)
500 (150)
500 (150)
1365x768
<250 (75)
>300 (90)
350 (105)
350 (105)
450 (135)
450 (135)
1366x768
<250 (75)
>300 (90)
350 (105)
350 (105)
450 (135)
450 (135)
1440x900
<250 (75)
>300 (90)
350 (105)
300 (90)
400 (120)
400 (120)
1400x1050
<250 (75)
>300 (90)
350 (105)
300 (90)
400 (120)
400 (120)
1600x1200
<250 (75)
>300 (90)
300 (90)
300 (90)
450 (135)
450 (135)
1920x1200
<200 (60)
>250 (75)
300 (90)
250 (75)
400 (120)
400 (120)
HDTV 720p
<250 (75)
>300 (90)
400 (120)
400 (120)
500 (150)
500 (150)
HDTV 1080i
<200 (60)
>250 (75)
300 (90)
250 (75)
400 (120)
400 (120)
HDTV 1080p
<200 (60)
>250 (75)
300 (90)
250 (75)
400 (120)
400 (120)
Figure 4.
Transmission Distance Table for Analog Signals
e
Optional MTP power output — This port is for use with an MTP/HDMI U R receiver,
and is rated at 12 VDC with a current draw of 1 A, 12 watts.
This supplies sufficient power via the MLS device to fully power the MTP unit.
NOTE:
When the power save mode is set to on, this port also turns off.
Captive Screw
Connector
Tie Wrap
3
5
Figure 5.
Wiring the MLS 608 D Power Output Connector
MLS 608 D Series • Rear Panel Connections
10