Extron Electronics ISS 108 - Manual (Page 62)

Programmer’s Guide, cont’d
Integration Seamless Switcher • Programmer’s Guide 4-16
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Command/response table for special function SIS commands
The syntax for setting a special function is
X n
*
X?
# where
X n
is the value or variable
(such as 35 in the first example below),
X?
is the function number (such as “set RGB
delay” in the first example below), and # is the execute command. To view a
function’s setting, use
X?
# where
X?
is the function number.
RGB delay and dissolve speed
RGB delay (Triple-Action Switching) X20 *3# Dly X20 Switching delay of the selected
input to the preview output.
Adjustable in 0.01 second steps
from 0 up to 50 = 5.0 seconds. 0
= 0.0 seconds (default), 1 = 0.1
seconds, 2 = 0.2 seconds, and so
on.
Example: 35*3# Dly35 RGB delay set to 3.5 seconds.
Dissolve speed X20 *5# Dur X20 Adjustable in 0.1 second steps
from 1 up to 50 = 5.0 seconds. 1
= 0.1 seconds (default), 1 = 0.1
seconds, 2 = 0.2 seconds, and so
on.
Switch effect
Switching effect X29 *4# Eff X29 Set the switch effect, 00 = cut or
01 = dissolve, used by the Take,
%, command.
Scaler output settings
Output sync format X8 *6# Syn X8 00 = RGBHV (default).
01 = RGBS.
Example: 1*6# Syn1 RGBHV output signal.
Output polarity X9 *7# Pol X9 X9 : Horizontal/Vertical polarity
0 = H–/V– 2 = H+/V–
1 = H–/V+ 3 = H+/V+
Example: 1*7# Pol1 H-/V+ output polarity.
Blue screen
Blue screen (blue & sync output only) X3 *8# Blu X3 0 = off (normal output).
1 = on (blue video & sync output).
Example: 1*8# Blu1 Blue & sync output for setup.
Edge smoothing
Edge smoothing X3 *16# Fil X3 00 = off.
01 = on (default).
Example: 1*16# Fil01 Enable edge smoothing.
Enhanced mode
Enhanced mode X3 *12# Enh X3 0 = off.
1 = on.
Example: 1*12# Enh01 Enable enhanced mode.