Extron Electronics ISS 108 - Manual (Page 58)

Programmer’s Guide, cont’d
Integration Seamless Switcher • Programmer’s Guide 4-12
Command/response table for SIS commands (cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
Vertical detail filter (RGB and component video inputs)
The vertical detail filter is available only for RGB and component video inputs.
The
X2
value specified is the output to which the filtered input is switched.
The command (d) is case sensitive.
Set a specific filter value X2 * X18 d X2 Dvz X18 Set the vertical detail level.
Increment filter value X2 +d X2 Dvz X18 Increase the vertical detail level.
Decrement filter value X2 -d X2 Dvz X18 Decrease the vertical detail level.
View the vertical filter value X2 d X18 Show the vertical detail level.
Detail filter (S-video and composite video inputs)
Composite and S-video inputs support a single detail filter only, rather than separate horizontal and
vertical filters. To apply a detail filter to the scaled output when the input is composite video or
S-video, use the same command as the horizontal filter (D) with the
X18
variable.
The
X2
value specified is the output to which the filtered input is switched.
Set a specific filter value X2 * X18 D X2 Dvz X18 Set the detail filter level.
Increment filter value X2 +D X2 Dvz X18 Increase the detail filter level.
Decrement filter value X2 -D X2 Dvz X18 Decrease the detail filter level.
View the vertical filter value X2 D X18 Show the detail filter level.
Auto Memories
Auto memories on 1M Aut X3 Set the ISS to apply auto
memories settings to all inputs as
selected.
Auto memories off 0M Aut X3 Set the ISS to not apply auto
memories settings.
View auto memories status M X3 Auto memories is X3 (on or off)
for all inputs.
User presets
The
X2
value specified is the output to which the input with the associated user preset is switched.
Save user preset X2 * X19
,
Spr X2 • X19 Command code is comma. Save
the
X2 outputs settings as preset
X19 .
Recall user preset X2 * X19
.
Rpr X2 • X19 Command code is period. Recall
preset
X19 settings for X2 output.
Freeze
Enable X2 *1F X2 Frz1 Output a “frozen” video image.
Disable X2 *0F X2 Frz0 Turn off freeze (output motion
video).
View the freeze status X2 F X3 Show the freeze status.
Example: X2 F 0 Freeze mode off.
Test pattern
Select test pattern for an output X21 * X22 J Tst X21 * X22 Select a test pattern for the X21
output(s).
View test pattern J X21 * X22 Show the test pattern.
Example: j 3*002 Crosshatch test pattern selected
for both outputs.