Extron Electronics ISS 108 - Manual (Page 34)

Operation, cont’d
Integration Seamless Switcher • Operation 3-12
Advanced Configuration menu
Figure 3-13 is a flowchart that shows an overview of the Advanced Configuration
menu, the submenus, and the available settings.
10 sec. 10 sec. 10 sec.
Dissolve Speed
1.0 Second
Default
Cycle
Default
Cycle
Menu
Menu
Next
10 sec.
10 sec.
Video & Audio
Configuration
Test Pattern
Color Bars
Program Preview
Off Off
Blue Only Mode
< Off > On
Edge Smoothing
< Off > On
Menu
Output
Configuration
Menu
Advanced
Configuration
Menu
User Presets
Menu
Next
Exit Menu
Press Next to Exit
Menu
10 sec.
Auto Imaging
< Off > On
Auto Memories
< Off > On
Enhanced Mode
< Off > On
Preview Switch Mode
Stay < Swap >
Reset Unit?
Press and Hold
BLACK/MUTE
To Reset
10 sec.
Next
Set test pattern type
• Color Bars
• Crosshatch
• 4x4 crosshatch
• Grayscale
• Crop
• Alternating pixels
• Film aspect 1.78
• Film aspect 1.85
• Film aspect 2.35
• Ramp
Change this setting
with either Adjust knob.
Change this setting
with either Adjust knob.
Select a test pattern
with the Adjust knob.
Select preview/program
off/on with the Adjust
knob.
Select blue mode with
the Adjust knob.
Select edge smoothing
with the Adjust knob.
• Output blue video
and sync only
• Enhance edges
To reset the scaler, press and
hold the Black button until
the reset message appears.
*Adjust knobs do not affect
this submenu.
Preview Blanking
Top Bottom
000 000
Select top blanking with
the Adjust knob.
Select bottom blanking
with the Adjust knob.
Program Blanking
Top Bottom
000 000
Select top blanking with
the Adjust knob.
Select bottom blanking
with the Adjust knob.
Next
Next
Next
Next
Next
Next
Next
Next
Next
Next
Select auto imaging
with the Adjust knob.
Select auto presets
with the Adjust knob.
RGB Delay
Preview 0.8 Seconds
Pixel Phase
Program Preview
016 016
10 sec. 10 sec. 10 sec.
10 sec.
PAL Film Mode
Input #2
< Off > On
Next
Select an input.
Change this setting
with either Adjust knob.
10 sec. 10 sec. 10 sec.
If necessary, select
another input and
repeat.
2
2
Time of the dissolve
(Dissolve button)
0.1 – 5.0 seconds
Change this value with
either Adjust knob.
Change this value with
either Adjust knob.
Change both values
simultaneously with
either Adjust knob.
Figure 3-13 — Advanced Configuration menu flowchart