Extron Electronics ISS 108 - Manual (Page 51)

4-5 Integration Seamless Switcher • Programmer’s Guide
Cutting or dissolving in swap mode
The switcher issues the following reports when you swap the preview and program
outputs in stay mode:
Tke
X4
(SIS operation response only) The
switcher has received the SIS “Take” (%)
command.
Bsy1 The switcher is busy and will not respond
to any SIS commands.
Out1•In
X1
• All (or RGB or Aud) The input to the program output has
changed (to the input that had been
switched to preview output).
Out2•In
X1
• All (or RGB or Aud) The input to the preview output has
changed (to the input that had been
switched to program output).
Bsy0 The switcher is no longer busy and is able
to respond to SIS commands.
Input and output video type
X1
Typ
X5
A front panel input video type selection has occurred.
X1
is the input number and
X5
is the input video type.
Rte
X6 X7
A front panel output video format selection has occurred.
X6
is the output
resolution and
X7
is the output refresh rate.
Syn
X8
A front panel output video type selection has occurred.
X8
is the output video
format (RGBHV or RGBS).
Pol
X9
A front panel output video polarity selection has occurred.
X9
is the output sync
polarity.
Picture adjustments
X2
Col
X10
A front panel color adjustment has occurred.
X2
is the output number switched to
the adjusted input and
X10
is the color variable.
X2
Tin
X11
A front panel tint adjustment has occurred.
X2
is the output number switched to
the adjusted input and
X11
is the tint variable.
X2
Brt
X12
A front panel color brightness adjustment has occurred.
X2
is the output number
switched to the adjusted input and
X12
is the brightness variable.
X2
Con
X12
A front panel contrast adjustment has occurred.
X2
is the output number switched
to the adjusted input and
X12
is the contrast variable.