Extron Electronics DVS 304 Series User Guide User Manual

Page 90

WARNING: Do not touch any switches or other electronic components inside the

scaler. Doing so could damage the scaler. Electrostatic discharge (ESD) can
damage IC chips even though you cannot feel it. You must be electrically
grounded before proceeding with any electronic component replacement.
A grounding wrist strap is recommended..

Locate the SDI card standoff located near the middle rear portion of the main circuit
board (looking from above with the front panel nearest to you)

Remove the plastic SDI cover from the rear SDI connector opening of the scaler and
position the SDI card at an angle with the SDI connector protruding from the rear SDI
connector opening.

The SDI card has a 20-pin socket on the underside which should align with the 20
pins on the main circuit board. Be sure to align the pins properly, in order to prevent
bending the pins, before pressing the SDI card firmly in place against the standoff.
The mounting hole on the SDI card should now be directly over the standoff.

Insert the card’s installation screw through the SDI card’s mounting hole and gently
tighten it into the standoff.

Install the SDI connector’s hex nut and keep the SDI card from twisting as the nut is
tightened.

Replace the top cover on the DVS 304 scaler, and fasten it with the screws that were
removed in step 3.

10.

Rack/furniture mount the scaler, if desired, and reconnect the AC power cord

DVS 304 Series • Reference Information