Exit menu, Resetting an input, Exit menu resetting an input – Extron Electronics DVS 304 Series User Guide User Manual

Page 28: Using the swap feature, Figure 23. exit menu

Using the swap feature

Use the swap feature to switch the active main window input with the current PIP input.
For example if the main window is Input 4 (RGB scaled) and the PIP window is Input 1
(composite), applying the swap command results in Input 1 becoming the main window
and Input 4 the PIP window.

For audio models (DVS 304 A, DVS 304 AD, DVS 304 DVI A, and DVS 304 DVI AD), you
can set audio to follow the main (default) or PIP window. Audio breakaway is not possible
while PIP mode is on; audio must follow either the main window or the PIP window.

Exit Menu

From this submenu, press the Menu button to return to the Start Auto Image menu cycle,
or press the Next button to return to the default cycle.

START AUTO

IMAGE ON IN1

INPUT

CONFIG

MEMORY

PRESETS

2 sec.

INPUT 1

COMPOSITE

OUTPUT

1024 x 768@60

Default Cycle

2 sec.

CONFIG

ADVANCED

CONFIG

TO EXIT MENU

PRESS NEXT

PICTURE

CONTROL

OUTPUT

CONFIG

AUDIO

CONFIG

(Audio models only)

Figure 23.

Exit Menu

Resetting an Input

Each input of the DVS 304 scaler can have its parameters, including auto memories, reset
to default values by holding down the specific input button together with the Menu
button, until the input number and Reset message is displayed on the LCD screen.

DVS 304 Series • Operation