Extron Electronics DVS 304 Series User Guide - Manual (Page 12)

i
RGB (RGBHV, RGBS, RGsB) or HD component (R-Y, Y, B-Y) video BNC outputs —
Connect cables from a display device to these BNCs for a scaled or pass-through RGB
or a scaled component video output. The output can be scaled to 69 different output
rates (see table on page 15).
NOTES: RGB pass-through is available on analog outputs only. The DVI output is
disabled for RGB pass-through.
RGBHV
H /
HV
R
/R-Y
V
G
/Y
B
/B-Y
R
/R-Y
G
/Y
B
/B-Y
RGsB
H/
HV V
R
/R-Y
V
G
/Y
RGBS\RGBcvS
H/
HV
B
/B-Y
B
/
B-Y
Component Video (Y, R-Y, B-Y)
R
/
R-Y
G
/
Y
H/
HV V
Figure 5. RGB Cabling
(DVS 304 models only) RGB or HD component (R-Y, Y, B-Y) 15-pin HD video
output — Connect an RGB video display or HD component video display to this HD
15-pin connector.
NOTE: Outputs are buffered and can be connected simultaneously to two different
displays. The sync and video formats will be the same for both outputs.
(DVS 304 DVI models only) DVI (digital and analog) output — Connect a
suitable display device to this DVI-I connector for scaled RBG or component video
digital and analog outputs.
j
Reset button and LED — Using an Extron Tweeker, pointed stylus, or ballpoint pen,
press this recessed button for manual resets. The unit has four modes of reset (see
“Resetting the Unit” later in this chapter for additional information). The green LED
flashes to show the reset mode indicators and that power is on.
k
LAN connector — Plug an RJ-45 jack into this socket to connect the unit to a
computer network. Use a patch cable to connect to a switch, hub, or router. See
figure 2-6 for wiring information.
LAN Activity LED — A blinking yellow LED indicates LAN activity.
Link LED — The green LED lights to indicate a good LAN connection.
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
Pin
1
2
3
4
5
6
7
8
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
T568A T568B
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
NOTE: If you are using Enhanced Skew-Free ™ A/V cable,
use the TIA/EIA T568A standard only.
Figure 6. Wiring the RJ-45
DVS 304 Series • Cabling 7