Start auto image menu, Input configuration menu, Picture control – Extron Electronics DVS 304 Series User Guide User Manual

Page 81

Start Auto Image Menu

Default Cycle

INPUT 1

COMPOSITE

2 sec.

OUTPUT

1024 x 768@60

START AUTO

IMAGE ON IN1

PRESS NEXT

TO START

Input Configuration Menu

START AUTO

IMAGE ON IN1

INPUT

CONFIG

INPUT 2

YUVi

INPUT 4

RGB SCALED

ASPECT RATIO

4x3

TTLPIX PHASE

XXXX 08

H START V

50 33

H ACTIVE V

XXX XXX

FILM MODE

SDI INPUT

<*> 1 2 3 4

Displays only when applicable

SDI DE-INTER

FIELD STNDRD

Displays only when applicable

DVS 304 DVI models only

Displays only on Input 4

Select video format
• Composite
• S-video
• YUVi
• YUVp/HDTV
• YUV Auto

Assign SDI to Input #
• 1, 2, 3, 4, * (none)

Select video format
• Composite
• S-video
• RGBcvS
• YUVi
• YUVp/HDTV
• RGB scaled
• RGB pass*
• Auto detect

Aspect ratio options
• 4 x 3
• 16 x 9

For YUVp or RGB input only

Total pixels
Specify the width
in pixels of the
total image area
sampled.

Pixel phase
Adjust the pixel
sampling point for
a selected input.

Horizontal start
Select for the
left edge of the
active video.

Vertical start
Select for the
top edge of the
active video.

Horizontal active
pixels
Specify the width
in pixels of the
active image area
sampled.

Vertical active
lines
Specify the
height in lines of
the active image
area sampled.

Film mode
Turn On or Off for low
resolution devices.

SDI De-interlacing options:
• Field Standard
• Field Flip

VGA EDID

1024x768@60

EDID Emulation
Specify the resolution
and refresh rate.

NOTE: Input 1 can only
accept composite video.
Input 3 can only accept
S-video. Only Inputs 2 and
4 can be configured for
different video types,
although an SDI input can
be assigned to any input.

NOTE: The SDI input signal
can be assigned to any
input. Once assigned to a
specific input, only an SDI
signal can be accepted on
that input. SDI can be
disabled by selecting the *.

NOTE: See table in the “Resolutions
and Refresh Rates” section, for EDID values.

NOTE: Not for use with
YUVp or RGB inputs.

NOTE: * RGB pass through is only
available on analog outputs.

Picture Control

INPUT

CONFIG

PICTURE

CONTROL

H POS V

000 000

COLOR TINT

064 064

DETAIL

064

H PAN V

000 000

ZOOM

100%

H SIZE V

1024 768

BRIGHT CONT

064 064

Tint adjustment applicable only for
NTSC composite or S-Video inputs

Only applicable when zoom is over 100 %

Horizontal
position
Adjust
horizontal
image
position.

Vertical
position
Adjust
vertical
image
position.

Detail
Adjust sharpness of
the image.

Zoom
Allows for 100-200% zoom
while the aspect ratio
remains unchanged.

Pan
Move the “zoomed”
image horizontally or
vertically. Available only
when zoom is set over
100%.

Horizontal
sizing
Adjust
horizontal
image
sizing.

Vertical
sizing
Adjust
vertical
image
sizing.

Brightness
Adjust image
brightness.

Contrast
Adjust image
contrast.

Color
Adjust color
of image.

Tint
Adjust tint
of image.

DVS 304 Series • Menu System