Xylem MULTI 3500i HANDHELD MULTIPARAMETER METERS - Manual (Page 80)

Operation Multi 3500i
78
4.10 Reset
You can reset (initialize) all sensor settings and sensor-independent
settings separately from each other.
4.10.1 Resetting the sensor settings
Note
The calibration data are reset to the default settings together with the
measuring parameters. Recalibrate after performing a reset.
pH The following settings for pH measurements are reset to the default
settings with the Reset function:
Oxi The following settings for DO measurements are reset to the default
settings with the Reset function:
Setting Default settings
Calibration type TEC
Cal. interval 7 d
Unit for slope mV/pH
Measured variable pH
High resolution On
Asymmetry 0 mV
Slope -59.16 mV
Temperature, manual 25 °C
Setting Default settings
Cal. interval 14 d
Comparison meas. Off
Measured variable DO concentration
Relative slope (S
Rel
) 1.00
Salinity (value) 0.0
Salinity (function) Off