Xylem handylab multi 12 - Manual (Page 61)

handylab multi 12 Operation
61 ba75371e03 11/2009
4.9 Reset
You can reset (initialize) the measurement parameters and the configuration
parameters separately from one another.
Measurement
parameters
The following measuring parameters (pH/O
2
/Cond InI) can be reset to the de-
fault condition:
pH
O
2
Conductivity
Note
The calibration data gets lost when the measuring parameters are reset.
Recalibrate after performing a reset.
Configuration
parameters
The following configuration parameters (InI) are reset to the delivery status:
Measuring mode pH
Asymmetry 0 mV
Slope -59.16 mV
Measuring mode D. O. concentration
Relative slope 1.00
Salinity (value) 0.0
Salinity (function) Off
Measuring mode
ӕ
Cell constant 0.475 cm
-1
(fixed)
Baud rate 4800
Display during the
pH calibration Buffer nominal value
Interval 1
(automatically saved)
OFF
Interval 2
(for data transmission)
OFF