Asus KFN5-Q/SAS - Manual (Page 95)

ASUS KFN5-Q Series 4-25
4.4.7 Power On Configuration
This menu shows the power configuration settings. Select an item then
press to display the configuration options.
Power On Configuration
Restore on AC Power Loss [Last State]
Resume on PME# [Disabled]
Resume on PCIE Wake# [Disabled]
Resume on Ring [Disabled]
Resume on PS/2 Keyboard [Disabled]
Resume on PS/2 Mouse [Disabled]
Resume on RTC Alarm [Disabled]
Configures the
system state after
recovering from power
failure.
Restore on AC Power Loss [Last State]
When set to [Power Off], the system goes into “off state” after an
AC power interruption. When set to [Power On], the system turns on
automatically after a power interruption. When set to [Last State], the
system goes into whatever was the system state (on or off) before the
power interruption.
Configuration options: [Power Off] [Power On] [Last State]
Serial Port2 Address [2F8/IRQ3]
Allows you to configure Serial Port2 Base Addresses.
Configuration options: [Disabled] [2F8/IRQ3] [3E8/IRQ4] [2E8/IRQ3]
Parallel Port Address [378]
Allows you to configure parallel port base addresses.
Configuration options: [Disabled] [378] [278] [3BC]
The following items appear when Parallel Port is enabled.
Parallel Port Mode [Normal]
Allows BIOS to select the Parallel Port Mode. Configuration options:
[Normal] [Bi-Directional] [ECP] [EPP] [ECP & EPP]
Parallel Port IRQ [IRQ7]
Allows BIOS to select the Parallel Port IRQ. Configuration options:
[IRQ5] [IRQ7]