Asus KFN5-Q/SAS - Manual (Page 86)

4-16 Chapter 4: BIOS setup
Memory Configuration
The memory configuration menu allows you to change the memory
settings.
Memory Configuration
Memclock Mode
[Auto]
MCT Timing Mode [Auto]
Bank Interleaving [Auto]
Node Interleaving [Disabled]
Enable Clock to All DIMMS [Disabled]
MemClk Tristate C3/ATLVID [Disabled]
CS Sparing Enable [Disabled]
Memory Hole Remapping [Enabled]
Select the DRAM
Frequency programming
method. If Auto,
the DRAM speed will
be based on SPDS.
If Limit, the DRAM
speed will not
exceed the specific
value. If Manual,
the DRAM speed
will be programmed
regardless.
Memclock Mode [Auto]
Sets the memory clock mode.
Configuration options: [Auto] [Limit] [Manual]
The following item appears when the Memclock Mode is set to Limit or
Manual.
Memclock Value [200 MHz]
Sets the memory clock mode limit.
Configuration options: [200 MHz] [266 MHz] [333 MHz]
MCT Timing Mode [Auto]
Sets the MCT Timing Mode. Configuration options: [Auto] [Limit]
Bank Interleaving [Auto]
Allows you to enable the bank memory interleaving.
Configuration options: [Disabled] [Auto]
Node Interleaving [Disabled]
Allows you to enable the node memory interleaving.
Configuration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ALTVID [Disabled]
Configuration options: [Disabled] [Enabled]
CS Sparing Enable [Disabled]
Configuration options: [Disabled] [Enabled]
Memory Hole Remapping [Enabled]
Enables or disables the memory remapping around memory hole.
Configuration options: [Disabled] [Enabled]