Asus KFN5-Q/SAS - Manual (Page 81)

ASUS KFN5-Q Series 4-11
4.3.4 IDE Configuration
The items in this menu allow you to set or change the configurations for
the IDE devices installed in the system. Select an item then press
if you wish to configure the item.
DISABLED: disables
the intergrated IDE
Controller.
PRIMARY: enables
only the Primary IDE
Controller.
IDE Configuration
OnBoard PCI IDE Controller [Both]
Serial-ATA Devices [Device 0/1/2]
nVidia RAID Setup
Primary IDE Master : [Not Detected]
Primary IDE Slave : [Not Detected]
Serial-ATA 0 Primary Channel : [Not Detected]
Serial-ATA 0 Secondary Channel : [Not Detected]
Serial-ATA 1 Primary Channel : [Not Detected]
Serial-ATA 1 Secondary Channel : [Not Detected]
Serial-ATA 2 Primary Channel : [Not Detected]
Serial-ATA 2 Secondary Channel : [Not Detected]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
ATA(PI) 80Pin Cable Detection [Host & Device)
OnBoard PCI IDE Controller [Enabled]
Enables or disables primary IDE controllers.
Configuration options: [Disabled] [Enabled]
Serial-ATA Devices [Device 0/1/2]
Enables or disables the SATA0/1/2 IDE interfaces.
Configuration options: [Disabled] [Device 0] [Device 0/1] [Device 0/1/2]
nVidia RAID Function [Disabled]
Enables or disables the nVidia RAID function.
Configuration options: [Disabled] [Enabled]
nVidia RAID Setup
This menu enables you to enable or disable RAID mode for each ATA
channhels while entering setup.
nVidia RAID Function [Disabled]
Enabled
Disabled
Options