Asus V66 - Manual (Page 3)

ii
Additional Information
The use of this equipment may be subject to
local rules and regulations. The following rules
and regulations may be relevant in some or all
areas.
FCC Regulations
This model phone complies with part 15 of the
FCC Rules. Operation is subject to the
condition that this device does not cause
harmful interference.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:(1) this device may not cause
harmful interference and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reason-
able protection against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and used
in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interfer-
ence will not occur in a particular installation If
this equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
Changes or modifications not expressly
approved by the party responsible for compli-
ance could void the user‘s authority to operate
the equipment.
The antenna(s) used for this transmitter must
not be co-located or operating in conjunction
with any other antenna or transmitter.
This EUT is in compliance with SAR for general
population /uncontrolled exposure limits in
ANSI/IEEE C95.1-1999 and had been tested in
accordance with the measurement methods
and procedures specified in OET Bulletin 65
Supplement C.