Asus GigaX3112 - Manual (Page 88)

75
GigaX3112 Series Layer 3 Managed Switch
5.3.10.3 default spanning-tree
This command sets spanning-tree parameter to default.
CLI Syntax: default spanning-tree
Example: ASUS# default spanning-tree forward-time
5.3.10.4 show spanning-tree active
To show spanning-tree active.
CLI Syntax: show spanning-tree active
Example: ASUS# show spanning-tree active
5.3.10.5 spanning-tree enable and disable
Enable/Disable the spanning tree.
CLI Syntax: spanning-tree (enable|disable)
Example: ASUS# spanning-tree disable
5.3.11 Link Aggregation
5.3.11.1 trunk aggregation group
Use the aggregation-link trunk group configuration command on the switch to
configure trunk aggregation group.
CLI Syntax: aggregation-link trunk STACKID group <1-32> PORTLIST
Example: ASUS#aggregation-link runk 1 group 1 1,2
5.3.11.2 trunk load balancing
Use the aggregation-link trunk group configuration command on the switch to
configure trunk load balancing by using source-based or destination-based
forwarding methods.
CLI Syntax: aggregation-link trunk STACKID load-balance group <1-32>
(src-mac |dst-mac |src-dst-mac |src-ip |dst-ip |src-dst-ip)
Example: ASUS#aggregation-link trunk 1 load-balance group 1
5.3.11.3 show aggregation-link trunk
To show aggregation-link trunk status.
CLI Syntax: show aggregation-link trunk STACKID [GROUPID]
Example: ASUS# show aggregation-link trunk 1 1