Asus GigaX3112 - Manual (Page 84)

71
GigaX3112 Series Layer 3 Managed Switch
5.3.4.3 Interface flow control
Use the flow control configuration command on the switch to set flow control
status of the port.
CLI Syntax: flowcontrol (rx| tx | both) (on|off)
Example: (config)# interface gi1/0/2
(config-if)# flowcontrol both on
This example shows how to use the flow control configuration command on the
switch to set flow control both on.
5.3.4.4 Show L2 interface
Use the show l2_interface command on the switch to show l2 interface status.
CLI Syntax: show l2_interfaces IFNAME
Example: ASUS# show l2_interface gi1/0/2
5.3.5 IP interface
5.3.5.1 show vlan name string
Use the show vlan user EXEC command to display the parameters for all
configured VLANs or one VLAN (if the VLAN ID or name is specified) on the
switch.
CLI Syntax: show vlan name string
Example: ASUS# show vlan VLAN1
Note: The vlan1 is for system purpose, for example, for firmware upgrade,
management, and so on.
5.3.5.2 Create a vlan entry
Use the vlan vid command to create vlan entry on the switch. Use the name
string command to create vlan entry with string on the switch.
CLI Syntax: vlan id
Example: (config)# vlan 3
(config-vlan)# name vlan3