3 area, 5 multicast route, 1 m-route – Asus GigaX3112 User Manual

Page 55

GigaX3112 Series Layer 3 Managed Switch

4.6.4.3 Area

This function is used to conﬁgure OSPF areas

Select a Area: Input area ID to be conﬁgured
Default Cost: Default cost for a stub area sending packet to outside world
Stub: Used to specify characteristics of this area(normal, stub no summary

and stub summary)
Range: Used to specify a set of network which belong to this OSPF area
Virtual Link: Used to specify a virtual link configuration, the other end

router-id of virtual link you want to establish is input on this ﬁeld

Figure 45 OSPF Advanced Conﬁguration 2

4.6.5 Multicast Route

This function is used to conﬁgure Multicast Route feature. It offers two different

methods including DVMRP and PIM-DM to establish multicast route. And, IGMP

will be automatically enabled/disabled with Multicast Route Protocol. It allows

hosts to communicate with their interest and desire data destined to a speciﬁc

multicast group. Multicast route protocol uses this information to build and

maintain multicast distributed tree.

4.6.5.1 M-Route

This command is used to conﬁgure IP multicast route mode and IGMP parameters.

IP Multicast Route Mode: Conﬁgure a multicast route protocol to run or disable.
IGMP Version: Select which version IGMP run. Default value is V2.
IGMP Query Interval: Set the number of seconds between two query

packets. Default value is 125 sec.
IGMP Query-Max-Response: Set response time when host reports its

multicast group. Default value is 10 sec.

This manual is related to the following products:

GigaX3112F