Asus GigaX3112 - Manual (Page 62)

49
GigaX3112 Series Layer 3 Managed Switch
Figure 54. SNMPv3 VGU Table 2
4.7.4.3 USM User
USM User is used to configure the information of SNMPV3 USM User.
User Name: User name of a specific security group
Group Name: enter the security group name
Auth Protocol: enter the Auth Protocol that SNMP User and Security Group
belong. Only NoAuth ,MD5, SHA1 can be chosen. If the NoAuth is chosen,
there is no need to enter password.
Auth Password: enter the password that the Auth Protocol belongs. The
password needs at least 8 characters or digits.
Priv Protocol: enter the Priv Protocol that SNMP User and Security Group
belong. Only NoPriv ,DES can be chosen. If the NoPriv is chosen, there is
no need to enter password.
Priv Password: enter the password that the Priv Protocol belongs. The
password needs at least 8 characters or digits.
Security level: enter the Security level Name that the Group belongs. Only
NoAuth, AuthNopriv, AuthPriv can be chosen.
Click on the Add when you create a new USM User entry by the above
information. Then you will see the new added entry shows in the User window.
You can remove the existed User by selecting the entry with the mouse, then
clicking on Remove. The Modify button updates the existed USM User entries.
Click to save effective. Click Reload to refresh the settings to current value. To
make the configuration effective, please go to “Save Configuration” page, then
click on Save.