Asus GigaX3112 - Manual (Page 54)

41
GigaX3112 Series Layer 3 Managed Switch
4.6.4.2 Interface
This function is used to specify some protocol parameters for a specific OSPF
interface
Network Type: Support broadcast only
Cost: Specify the cost for sending packet of this interface
Priority: Set priority to help determine the OSPF DR and BDR for a network
Transmit Delay : Set the estimated number of seconds to wait before
sending a link update packet
Hello Interval: Set the number of seconds between two hello packet, 10
seconds is set as default value
Dead Interval: Set the number of seconds after the last hello packet was
received before declare its neighbor OSPF router is down, 40 seconds is set
as default value
Retransmit Interval: Specify number of seconds between link state
advertisement transmission
Figure 44. OSPF Advanced Configuration 1