GE Industrial Solutions GERAPID 2607, 4207, 6007, 8007 with arc chutes 1X2, 1X4, 2X2, 2X3, 2X4 - Manual (Page 43)

2010-06-07 S47183e rev.03 Design and specifications are subject to change without notice 43
6.2.1 Contact system (after 11/2003).
Pay attention to the warnings, Section 1!
This section is valid for breakers manufactured after
11/2003.
This section refers to maintenance works A, B, C from
Table 4.
A) Remove the arc chute
•
[Fig. 49]. Loosen the screws (3) and (4), using SW5
hexagon wrench and take off the arch chute (1) from the
adapter (2).
B) Remove the arc chute adapter
• [Fig. 48]. To dismantle the arc chute adapter, loosen and
pull out the four upright screws (1) using SW5 tool. Pay
attention that no screws or washers fall inside the
breaker!
• [Fig. 48]. Draw aside and lift off both parings of adapter
(2). Then pull out two protective walls (3).
C) Changing the protective walls, arc runners and arcing
contacts
•
[Fig. 48]. Pull out two protective walls (3).
• [Fig. 50]. Loosen screws (6a) with tool (SW4) and take out
front wall (6).
• [Fig. 50]. Loosen screw (5a) with tool (SW5) and take out
the front arc runner (5).
• [Fig. 50]. Take out the back arc runner (4) by loosening
two screws (4a) with tool (SW5). Don’t remove the
protective cap (4b).
• [Fig. 50]. Loosen and take out screw (7) including locking
plate (8). Don’t split up screw and locking plate!
• [Fig. 50]. Pull out axis pin (9). Pull out arcing contact (10)
and put in new arcing contact.
• [Fig. 50]. Put in axis pin (9) and protect it by the locking
plate (8). Tighten screw (7) with torque of 10 Nm [88 in-
lbs].
• [Fig. 50]. Install front-arc runner (5) and back-arc runner
(4). Tighten it using torque of 10 Nm [88 in-lbs].
• [Fig. 50]. Install front wall (6) and adjust it by positioning
the protective wall. Tighten with torque of 10 Nm [88 in-
lbs].
• [Fig. 48]. Put in two protective walls (3).
D) Install the adapter
•
[Fig. 48]. Install two protective walls (3). Use new ones if
necessary. Install two parings of adapter (2) and tighten
screws (1); use 5 Nm [44 in-lbs].
E) Install the arc chute
• [Fig. 49]. Put in arc chute (1) into adapter (2).
• [Fig. 49]. Tighten front- and backside connections of the
arc runners (3), including lock washer; use 10 Nm [88 in-
lbs].
• [Fig. 49]. Tighten front- and backside of the arc chute
connections (4), including flat washers; use 5 Nm [44 in-
lbs].
Fig. 48 Adapter and protective walls
Fig. 49 Arc chute and arc runners fixing
3
1
2
4
5
2
1 3