GE Industrial Solutions LP33 Series 80 & 100 Installation Guide - Manual (Page 14)

Modifications reserved Page 14/47
OPM_LPS_3UI_80K_M10_1US_V010.doc Installation Guide LP33 Series 80 & 100 UL S1
3.2 DELIVERY
When delivered, check carefully the package integrity and the physical conditions of the UPS
equipment.
In case of any damage sustained during transport, immediately inform the carrier and contact your
local Service Center.
A detailed report of the damage is necessary for any insurance claim.
NOTE !
A damaged UPS must never be installed or connected to utility or battery!
3.3 STORAGE
The equipment is carefully packed for transport
and storage so that it is in a perfect condition
when eventually installed.
Never leave an UPS outside the building and do
not store the UPS one on top of the other.
It is recommended to store the UPS in its original
package in a dry, dust free room and far away
from chemical substances, with temperature
not exceeding -13°F to 131°F (-25°C to 55°C).
In case the battery is included please refer to
Section 3.3.2.
3.3.1 Storage of the UPS
Some important functions of the UPS, such as the customized functions, are defined by parameters
stored in a RAM memory.
The RAM is supplied by a small backup battery located on the Control Unit board.
If the storage time of the UPS exceeds 1 year, these functions should be verified by an authorized
Service Center before putting the UPS into operation.
NOTE !
In case of storage of the UPS pay attention to:
FRAGILE
SENSITIVE
TO DAMPNESS TO HEAT
SENSITIVE
TO FROST
SENSITIVE