B&B Electronics EIR508-T - Manual - Manual (Page 18)

18
Manual Documentation Number: EIR508-2xx-T 1713m
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Wiring the Fault Alarm Contact
The fault alarm contact is located in the middle of terminal block connector
as shown below. Insert the wires and set the Dipswitch
to “ON”. When a
power source fails or a link fault occurs the relay contacts will close.
[NOTE] Use12~ 24 AWG wire.
[NOTE] Relay contacts are normally open.
[NOTE] The Relay Alarm also requires software configuration. Refer to the
Web Based Management Alert Section.
Insert the wires into the fault alarm contact
1A@24V