B&B Electronics SPP-100 - Manual - Manual (Page 39)

conflicts can be resolved by switching to one of the predefined
basic configurations then skip down to the last step.
7. To modify any of the system resource showing a conflict click
the resource name and click the Change Setting button. An Edit
Resource window will open up. Note that the I/O address
resources for basic configurations 0 and 1 are not allowed to be
changed.
Figure 14. Windows 2000/XP Edit Resources Window
8. Inside the Edit Resource window click on the up/down arrows
to the right of the resource value. This scrolls you through all of
the allowable resources for the SPP-100. Pay attention to the
conflict information at the bottom of the window. Select a
resource value that reports "No devices are conflicting". Click
OK to save your changes, or Cancel to abort.
9. Repeat the above steps to resolve of resource conflicts. Once
satisfied with the settings make a note of the new settings and
click the
OK button to accept. Clicking the Cancel button does
not save your changes.
10. Windows 2000/XP enumerates the SPP-100 to the first available
LPT port number. Use this Logical LPT Port name to access the
Quatech Inc. 5-7