B&B Electronics SPP-100 - Manual - Manual (Page 21)

3. Windows 95/98/ME Installation
To simplify the installation of the SPP-100 on Windows 95/98/ME based
systems, an
configuration file is provided on the distribution disk. This
configuration file supports the SPP-100 in both standard printer port
mode and EPP mode.
3.1 Installing an SPP-100 in Windows 95/98/ME.
1. Insert the SPP-100 into any available PC Card socket.
2. The first time a new PC Card type is installed the New
Hardware Found window opens. After this first installation
Windows 95/98/ME will automatically detect and configure
the card. If the New Hardware Found window does not open,
then skip to the next section, "SPP-100 Resource Settings".
Figure 3. SPP-100 Driver Installation in Windows 95/98/ME
3. The New Hardware Found window provides several options to
configure the SPP-100 card. Click the Driver from Disk option
button. Click OK to continue.
4. An Install From Disk dialog box should open. Insert the
SPP-100 drivers diskette, select the correct drive letter, and click
the
OK button. Windows 95/98/ME automatically browses the
root directory for an INF file that defines configurations for the
SPP-100 User's Manual 3-1