B&B Electronics SPP-100 - Manual User Manual
Page 18
Before removing an SPP-100 from its PCMCIA socket, the Enabler should
be executed to free the system resources allocated when the card was
installed. For this operation the Enabler provides on additional command
line option:
R
instructs the enabler to release the resources previously
allocated to the SPP-100. When the 'R' option is used, any
settings specified by the 'B', 'I', 'E', and 'L' options are ignored.
2.2.1.1 Example 1
SPP100EN.EXE
In example 1, no command line argument is specified. The Enabler will
report an error and display the proper usage of the command.
2.2.1.2 Example 2
SPP100EN.EXE (s0,b378,i7)
In example 2, the Enabler will configure the SPP-100 in socket 0 with a
base address of 378H and IRQ 7 using a configuration memory window at
segment D000. The SPP-100 will operate as a standard printer port, and
the BIOS equipment list will not be updated.
2.2.1.3 Example 3
SPP100EN.EXE (i10,l,e,b340,s1)
In example 3, because the parameter order is not significant, the Enabler
will configure the SPP-100 in socket 1 with a base address of 340H and
IRQ 10 using a configuration memory window at segment D000. The
SPP-100 will operate in EPP compatible printer port mode and the BIOS
equipment list will be updated.
2-10
Quatech Inc.
20