Moog Music Taurus 3 Bass Pedals - Manual (Page 42)

Page 44
Taurus 3 User’s Manual - The User Interface
Page 45
Taurus 3 User’s Manual - The User Interface
F. System Utilities Menus
System Utilities provide a set of useful system-level commands to set global options, restore factory defaults
and calibrate the T3. To enable System Utilities menus, press the CURSOR button. This will highlight the
menu options shown on the second line of the display. Once highlighted, use the VALUE knob (or press the
VALUE pushswitch) to scroll through the menu.
Allows you to enable or disable menu wrapping. When menu wrap-
ping is enabled (‘ON’), menus and Preset numbers will wrap back to the
beginning when you reach the end. When disabled (‘OFF’), menus and
Preset numbers will not wrap. To enable/disable menu wrapping, press
the CURSOR button to move the cursor to the ON/OFF parameter
field, then use the VALUE knob to select the desired value. The default
is ‘ON’.
This menu simply displays the current version of the operating system.
VERSION (VERS):
MENU WRAP:
Allows you match the T3’s output level to the amplifier. Generally, the
MASTER VOLUME parameter should be set so that the maximum
desired volume for any preset is achieved when the VOLUME footwheel
is set to maximum. When using the T3 with a bass amplifier, plug the
Taurus into the high-level amplifier input and set the amplifier volume
control about 1⁄2 of the way up or less. With the VOLUME footwheel at
maximum, set the MASTER VOLUME parameter for the desired volume.
To adjust the setting, press the CURSOR button to move the cursor to
the value field, then use the VALUE knob to select the desired value
.
MASTER VOLUME:
TECH NOTE: The MASTER VOLUME parameter duplicates the
function of the Output Level rotary control found on the Taurus 1.
Allows you to turn the footwheel lights ON or OFF, or have them pulse
at the LFO rate (both the VOLUME and CONTROL footwheel LEDs will
pulse, providing a visual indication of the LFO rate). To adjust the setting,
press the CURSOR button to move the cursor to the value field, then use
the VALUE knob to select the desired value.
Values: ON, OFF, LFO; the default is ON
FOOTWHEEL LIGHTS (FW LIGHTS):